Moving from Analog or ISDN Lines to VoIP: A Migration Checklist
Telephone carriers are retiring the copper networks that carry analog and ISDN lines, and businesses still using them have to move to VoIP on someone else's timetable. The phones are the easy part. What catches people out are the alarm panel, the lift phone and the fax machine nobody remembered. This checklist takes you from inventory to cutover, with the decisions and tests that keep calls and devices working.
Why now: switch-off timelines
- United Kingdom: Openreach states that on 31 January 2027, all traditional phone lines will be going digital. Its press notes add that the switch-off affects all services powered by copper lines, including ISDN. Openreach describes a limited temporary service for lines that haven't moved in time, which may not support all calling features, so don't plan around it.
- Germany: Deutsche Telekom said in May 2020 that the migration of its remaining voice-only and ISDN lines to IP would be completed that year.
- Elsewhere: dates vary by country and carrier, and some have no fixed date yet. Ask your carrier for its plan in writing, and check your telecom regulator's website.
Even without a deadline, ageing ISDN equipment and the PBXs attached to it get harder to repair each year. Moving on your own schedule is far less stressful than moving on the carrier's.
The terms you'll meet
| Term | What it is |
|---|---|
| Analog line (PSTN) | A traditional copper phone line: one call at a time, powered from the telephone exchange |
| ISDN BRI | A digital line with two voice channels, so two calls at once (ISDN2 in the UK) |
| ISDN PRI | A larger digital circuit: up to 30 channels on European E1 lines (ISDN30 in the UK), 23 on North American T1 lines |
| DDI / DID | Direct dial-in numbers: a block of numbers routed over one line or trunk, each reaching a different extension |
| SIP trunk | Phone lines delivered as a service over your internet or data connection, sold by channels |
| ATA | Analog telephone adapter: connects an analog phone, fax or device to a VoIP system |
| VoIP gateway | A box that connects an ISDN or analog PBX, or several analog devices, to SIP |
Choose your migration path
| Path | Pros | Cons | Good fit |
|---|---|---|---|
| Keep your PBX and add a SIP-to-ISDN or analog gateway | Least change, same handsets | The old PBX keeps ageing; few new features; one more box to fail | A PBX bought recently, or a lease with time left |
| New on-premise IP PBX with SIP trunks | Full features, local control, analog ports for special devices | Hardware or server to maintain, network must be ready | Sites with many analog devices or strict local control needs |
| Hosted PBX | No PBX hardware, works anywhere | Every call depends on the internet link; devices still need ATAs or their own solutions | Offices with few special devices and staff who work remotely |
Our comparison of hosted vs on-premise PBX covers cost and control in detail, and SIP trunking explained shows how trunks replace ISDN channels.
The migration checklist
Phase 1: Inventory everything
- Collect the latest bills and ask your carrier for a list of every line, number and DDI range on your account.
- Walk the building and label every socket and device that's connected, including those in plant rooms, lift shafts and reception desks.
- Map your call flows: which number rings where, hunt groups, night service, voicemail and any numbers printed on vehicles or signs.
- Note contract end dates and notice periods for every line, so you don't pay twice or get cut off early.
Openreach lists devices that may be affected: alarms, CCTV, payment terminals, telecare and health monitoring equipment, door entry systems and lift phones. Treat each one as its own small project.
| Device | What to check | Typical route |
|---|---|---|
| Intruder and fire alarms | Ask the alarm installer or monitoring center whether the panel can signal over IP or cellular | IP or 4G communicator approved by the alarm company |
| Lift emergency phones | Ask the lift maintenance company; these are safety devices | Often a dedicated 4G unit |
| Fax machines | Is fax still needed, and by whom? | Email-to-fax service, or an ATA using ITU-T T.38 fax over IP, supported end to end |
| Door entry and gate intercoms | Analog or SIP model? | SIP intercom, or an analog port on the PBX or ATA |
| Card terminals and franking machines | Do they still dial out over the phone line? | IP, Wi-Fi or 4G versions from the supplier |
| Telecare and health alarms | Who depends on them? | Agree a plan with the device supplier before cutover |
Phase 2: Size and design
- Size channels from data, not from the old line count. An ISDN30 with 20 channels doesn't mean you need 20 SIP channels; measure your real peak. Our guide to how many simultaneous calls you need shows how.
- Check bandwidth, especially upload: Cisco's planning figure is about 87.2 kbps each way per G.711 call on Ethernet.
- Plan resilience: a second connection or 4G backup, and a failover destination at the SIP provider, such as mobile numbers, for when your site is offline.
- Plan for power. Analog lines were powered from the exchange; as Openreach puts it, digital phone lines need power to work. Put the router, PoE switch, PBX and any ATAs on a UPS, decide how long it must last, and keep a charged mobile phone for emergency calls.
Phase 3: Numbers
- Start porting early. It often sets the go-live date. Port whole DDI ranges, plus fax and alarm numbers that are still needed. The process is covered in number porting: keep your business numbers.
- Don't cancel any line until its numbers have moved.
- Decide outbound caller ID for each team, and confirm the new provider lets you present your ported numbers.
Phase 4: Network and security
- Set up a voice VLAN and QoS on the internet router; see QoS for VoIP.
- Disable SIP ALG and allow SIP only from your provider's addresses.
- Lock down international dialing and admin access before the trunk goes live, not after.
Phase 5: Emergency calls
Register the correct site address with your SIP provider for every number that may call emergency services, and ask how it handles staff who work from elsewhere. Rules differ by country. This is general information, not legal advice; check the rules that apply in your country.
Phase 6: Build and test
- Inbound calls to every main number and DDI, from a mobile on another network
- Outbound caller ID on each route
- Transfers, voicemail, IVR, night service and hunt groups
- A real fax in both directions
- A test signal from each alarm to its monitoring center, and a call from each lift phone
- Failover: unplug the main internet connection and call in
- Emergency calling, using the test procedure your provider recommends
Phase 7: Cutover and clean-up
- Cut over on a quiet weekday, with someone on site and a rollback plan.
- Train staff on transfers, voicemail and the apps before the day, not after.
- Once every number has ported and every device is confirmed working, cease the old lines in writing.
- Check the next two bills for lines still being charged, and remove the old equipment.
A sample timeline
| When | Tasks |
|---|---|
| 12 to 8 weeks before | Inventory, contract review, contact alarm, lift and payment suppliers |
| 8 to 6 weeks before | Choose the platform, order trunks and any new connection, submit port requests |
| 6 to 3 weeks before | Network changes, PBX build, special device replacements |
| 3 to 1 weeks before | Full testing, pilot with one team, staff training |
| Cutover week | Port completes, final tests, old system kept on standby |
| 2 to 4 weeks after | Cease old lines, check bills, tidy up call flows |
Larger sites, multiple DDI ranges or a backlog of special devices can stretch this. The earlier you start the inventory, the less the carrier's deadline matters.
Common mistakes
- Forgetting non-phone devices: alarms and lift phones fail silently until the day they're needed.
- Ceasing lines before the port completes, which can lose the numbers.
- Assuming the old channel count is the requirement and paying for capacity you never use.
- No power plan, so a short power cut takes out every phone.
- Testing only the main number, then finding a DDI range didn't port.
For the full picture of choosing and running the new system, see our business VoIP phone system guide.
How BtoBSkills can help
Our VoIP installation and configuration service starts with a call to scope your migration, then covers installation and configuration of extensions, trunks, call routing, queues and IVR, on 3CX, Yeastar, FreePBX and other Asterisk-based platforms. We can also upgrade an existing system rather than replace it. Request a quote with your current line types, number of users and any special devices.
Frequently asked questions
Can I keep my current phone system after ISDN is switched off?
Will my alarm still work after the switch to digital?
Do analog phones work with VoIP?
What happens if I miss the switch-off date?
Related services
Related articles
- Hosted PBX vs On-Premise PBX: Costs, Control and Which to Choose
Hosted and on-premise PBXs compared on cost, control and outage risk, with a break-even method for your own quotes and a guide to which model fits.
- SIP Trunking Explained: How It Replaces Traditional Phone Lines
What a SIP trunk is, how channels, numbers and authentication work, what it replaces, how providers package it and what to check before you sign.
- How Many Simultaneous Calls Does Your Business Need?
What counts as a simultaneous call, how to measure your busiest hour, a worked Erlang B example and how to turn the result into a 3CX license or Yeastar capacity.
- QoS for VoIP: How to Prioritize Voice on Your Network
Where voice actually gets delayed, which DSCP markings to use, how to set priority queues and shaping on your router, and a simple test to prove it works.
- Business VoIP Phone Systems: The Complete Guide for SMEs
How a business VoIP phone system works, the deployment and licensing choices you'll face, what your network needs, and how to switch without losing calls or numbers.
Sources
- Openreach: Upgrading the UK to digital phone lines (accessed 2026-11-19)
- Openreach: Time for a big switch-up as PSTN switch-off looms (5 February 2026) (accessed 2026-11-19)
- Deutsche Telekom and VATM: Telekommunikationsunternehmen schliessen IP-Migration der Datenanschlüsse ab (20 May 2020) (accessed 2026-11-19)
- ITU-T Recommendation T.38: Procedures for real-time Group 3 facsimile communication over IP networks (accessed 2026-11-19)
- Cisco: Voice Over IP - Per Call Bandwidth Consumption (accessed 2026-11-19)


